Build Diary – John's Guitar Site

Dread Build Pictures

Very please with neck fit. Could have done more with bandsaw, try retro cut the nibs Gap at saddle is

Damage the top again, filled with SG but should have used solder iron. Blue tape on top, grain tear out.

When drilling side holes scribe a line all the way round to mark the bolt locations Bottom hole is to

Small blade in the bandsaw, better

Make sure the grain orientation of the donut matches he top. Spend more time getting neck interface flat before binding

Mahogany was a write off, broken. Sanded to about 1.95mm and bent at 121 – 160 degrees and wrapped in

All reading for binding.